Hello all, a buddy of mine introduced me to this awesome forum. I feel a lot more at home while browsing through this forum. My first passion was competing in IASCA, but hunting for JDM parts was a close second Here's a pic of my GE8 Fit. Here's a rundown of the parts: Interior: Arm rest Door stills Honda all-season floor mats TSX Homelink mod Mugen pedals Mugen sphere shiftknob DA Integra trunk light JDM Red hazard switch JDM Coin holder Recaro door inserts H-Fit shift kit Gentex Auto dimming mirror Autometer water temp/volt meters - DIY gauge cluster Exterior: Honda window visors Honda Rear bumper applique Mugen front grill JDM folding mirrors with blinkers Honda Access Aquaclean mirrors JDM Base Fit tail lights Wheels/suspension/brakes: Buddy Club N+ coilovers Progress rear swaybar Cusco FSB Tiger Tuning front tie bar and 4pt subframe bar Integra ITR DC2 front calipers Fast Brakes 4x100 11” rotors Mugen MF-8 Falken ZX912 205/50/16 tires Engine bay: CRZ front under panel Mugen oil cap Carbing radiator cap Stinger SPV35 (Odyssey) Spoon trans/oil drain plugs K&N drop in filter Audio Pioneer DEX-P99RS Phoenix Gold (2)M50 & M25 Kenwood XR-1s Scan Speak 15WU/4741T mids Scan Speak D3004/6020 tweeters (2) Tang-Band WT-1427G subs To do list Shave/delete rear tailgate wiper Replace front swaybar link with a shorter ones - the geometry is off and it keeps hitting the lower control arm. Maybe a Cusco swaybar while im at it hehe J’s rear tower & C-pillar bar Honda Access mini spoiler ("small type"). Still trying to confirm if the mounting points are the same as the usdm. If not, I would like to go wingless (my original plan) but im not sure if I want to have the wing mounting holes shaved Trying to decide if I want to have the MF-8 center caps powder coated black To do but probably wayyyy down the line ITR JDM DC2 or EP3 seats + Bride rails. Still waiting for Buddy Club to make bottom mount rails (save some $$$) A lot of the ideas for the DIY mods were from Fit Freak